User`s manual

Magtrol WB/PB DynamometersChapter 4 – Connections / Conﬁguration

4.3.2 torque SignAl connection

The torque signal is supplied by a load cell ﬁtted with a bridge strain gauge.













1. Signal +

2. N/C

3. Signal –

4. Supply +

5. N/C

6. Supply –

Figure 4–10 Connector Pin Conﬁguration for WB/PB 2.7 and 43 Dynamometer Torque Signals

Note: The use of shielded cable is mandatory. Connect cable shielding

to the connector housing.

A Signal +

B. Signal –

C. Supply +

D. Supply –

E. Shield

Figure 4–11 Connector Pin Conﬁguration for WB/PB 65, 115 and 15 Dynamometer Torque Signals

Note: The use of shielded cable is mandatory. Connect cable shielding

to the connector housing.