Installation Instructions

NOTICE

This unit can evaporate the condensation and flow out through the exhaust hose

automatically.

1. When the unit is in the cooling function, it does not need the exhaust hose installed.

Please make sure that the rubber cap is locked on drain hose, when the unit is

running.

2. When operating the heating function, the “①” rubber cap on drain hose should be

pulled out and install a proper drain hose in order to improve the heating effect

3. When operating the dehumidifying function the “①” rubber cap on drain hose should

be pulled out and install a proper drain hose.

● Please remove the air exhaust hose, connect a drain hose to the drain hole and

lead the water to the outside in order to let the dehumidifying capacity intensify.

※ When the water tank is full,"E4" will be displayed on the display panel. To resume

operation, please remove the rubber cap“②” of the drain hose to drain out the water

first. After drainage is complete, please restart the unit and then the unit can operate

normally.

MAINTENANCE

PLEASE DISCONNECT THE POWER CORD BEFORE CLEANING.

AIR FILTER

The air filter located on the left hand side of the unit can be removed,

simply by pulling the frame in an upward motion.

CONDENSER/EVAPORATOR

Use a brush attachment with a vacuum cleaner.

CABINET

Wipe with a damp cloth and polish with a soft cloth.

To remove the air filter, please follows the arrow direction and push the

filter lightly, and then take out the filter for cleaning.