Instructions / Assembly

13 of 16
the door is stained allow material to dry. Follow
instructions of the stain manufacturer.
5. Apply a minimum of two coats of clear
Polyurethane or Varathane. Spray applications
will achieve the best results. Make sure the door
is sealed on all SIX sides.
Follow the same procedure to stain other parts of the
unit, e.g., jamb sets or moldings.
FAILURE TO FOLLOW PROPER FINISHING INSTRUCTIONS
AND ADEQUATE PROTECTION FROM WEATHER WILL
VOID THE WARRANTY!
PAINT- Finishing instructions
1. Lightly block sand the surfaces of the unit with
sandpaper 150 grit in the direction of the wood
grain. Never sand cross grain!
2. Clean unit from all dust.
3. Seal door with quality primer on all six sides.
Allow primer to dry thoroughly(check instructions
of manufacturer)
4. Sand lightly with Sandpaper 320 grit and clean
off dust. Apply second coat of primer. Make
sure to use compatible materials.
5. After drying, sand with sandpaper 320 grit, clean
off dust and apply one even coat of to paint.
FAILURE TO FOLLOW PROPER FINISHING INSTRUCTIONS
AND ADEQUATE PROTECTION FROM WEATHER WILL
VOID THE WARRENTY!