Use and Care Guide

Directions for use:
1. Always connect the QwikInjector
®
to the low side of an operating
system before connecting to the high side.
2. Never leave the QwikInjector
®
connected to the hoses. After use,
always disconnect and disassemble.
3. Before unscrewing the cover, always check for any pressure build
up by depressing the valve core depressor.
4. Always store the
QwikInjector
®
with the cap screwed on loosely to
prevent thread binding and pressure build-up.
For more details or information about QwikInjector® or QwikShot® visit www.qwik.com
MKTG000062 _REV-B / 2000804
QwikProducts™ is a trademark of Mainstream Engineering Corporation. QwikInjector®,QwikShot® and
Mainstream Engineering Corporation® are registered trademarks of Mainstream Engineering Corporation,
Rockledge, Florida 32955, [phone] . U.S. Patent #5,996,651 and other Patents Pending. All
QwikProducts™ are made in the USA
QwikInjector
TM
Mainstream Engineering Corporation®
1-800-866-3550
www.qwik.com
QwikInjector®
Additive Injection Tool
QT2510: 0.5 oz. QT2520: 2 oz.
QT2511: 4 oz.
QwikInjector
®
is used to deliver any liquid (such as
QwikShot
®
) into the low side of a charged system.
It is compatible with all refrigerants and oils,
including R-410A. This rugged aluminum tool is
used with any ordinary gauge set to inject liquid
additives into the system.
X Tested & Approved for R-410A
X Rated for 800 psig
X Compatible with ALL oils, dyes and...
QwikShot
®
Refrigerant & Oil Treatment
,
QwikGlowPro
®
Leak Detector,
and QwikSeal
®
AC/R Leak Sealant w/Drying Agent
PROUDLY MADE
IN THE U.S.A.