Instructions / Assembly

Simple Installation Instructions
Flush Bottom
Panel Style
Picket Bottom
Panel Style
Screw Placement
Screw Placement
Figure 1
Figure 2
Step 1
Insert 3’ section of Puppy Guard to yard side
of your installed fence section as shown in
Figure 1. Bottom pickets on Puppy Guard
should rest on bottom horizontal rail of
installed fence section. Horizontal rail ends on
Puppy Guard should meet at center of center
vertical picket on installed fence section.
Attach using 4 - #8 x ½” self tapping screws.
Step 2
Insert second 3’ section of Puppy Guard
opposite installed section of Puppy Guard
as shown in Figure 2. Bottom pickets on
Puppy Guard should also rest on bottom
horizontal rail of installed fence section as
instructed in step 1. Make sure horizontal
rails ends on both sections of Puppy Guard
meet on center of vertical picket on
installed fence section before attaching.
Attach using 4 - #8 x ½” self tapping screws.
PATENT PENDING
Included In Box:
•2 – 3’ Puppy Guard Panels (if purchased)
•2 – 3’ Puppy Guard Strips (if purchased)
•#8 x ½” Self-Taping Screws
Needed For Installation:
•Power Drill w/ #1 Phillips Screw Bit
•(Optional) Jigsaw for Trimming