Installation Manual

51
Majestic • ECHEL36IN/STIN, ECHEL48IN/STIN, ECHEL60IN, ECHEL72IN Installation Manual • 2406-970 Rev. C • 1/17
Facing Material
• Facing and/or fi nishing materials must not interfere with
air fl ow through louvers or decorative fronts.
• Facing and/or fi nishing materials must never overhang
into the glass opening.
• Observe all clearances when applying combustible
materials.
Figure 10.2 Finishing and Facing Materials - Single-Sided Models
Finishing - Hearth
See Inside Fit or Overlap Method sections to determine
the necessary requirements for installation of a non-
combustible hearth for this model. Only hearths made of
non-combustible materials are allowed.
1/2 IN. THICK WALL
SHEATHING
BOTTOM
FINISHING
TEMPLATE
FINISHING
GUARDS
NON-COMBUSTIBLE
FINISHING MATERIAL
OVERLAP FIT = 0-1 IN. THICK
INSIDE FIT = 1-4 IN. THICK
Decorative facing material thickness is measured from
the face of the installed non-combustible board. See Fig-
ure 10.2 and Figure 10.3.
The fronts for this appliance are compatible with non-
combustible materials. See Figure 10.2 and Figure 10.3.
Refer to Section 1.E and 1.F of this manual for defi nitions
and qualifi cations of non-combustible and combustible
materials.
Specifi c requirements for each method of installation are
described in this section.
Installation of fi nishing materials can be accomplished by
either the “overlap” or “inside-fi t” method, depending on
what type of decorative front is to be installed. See Figure
10.2 and 10.3. For an overlap fi t option with the Echelon,
the Picture Frame Front (PFF) is available. The Clean
Face Trim Front (CFT) can be either an inside fi t or an
overlap fi t. See Table 1.
Decorative Front Finishing Method Material Thickness Trim Ring
Clean Face Trim (CFT)
Inside Fit 1-4 inches
Included & Not Used (Option #1)
Included & Used (Option #2)
Overlap Fit 0-1 inch Included & Used
Picture Frame Front (PFF) Overlap Fit 0-1 inch Not included
Picture Frame Front (PFF) Inside Fit 1-4 inches Not included
Table 1.