Installation Manual

60
Majestic • ECHEL36IN/STIN, ECHEL48IN/STIN, ECHEL60IN, ECHEL72IN Installation Manual • 2406-970 Rev. C • 1/17
11
11
Appliance Setup
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the rebox or underneath in the control cavity.
Figure 11.1 Fixed Glass Assembly
A. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
DO NOT strike, slam or scratch glass.
DO NOT operate replace with glass removed, cracked,
broken or scratched.
Replace as a complete assembly.
Removing Fixed Glass Assembly
1. Remove the decorative front from replace and set
aside on work surface.
2. Remove bottom glass shield. See Figure 11.2.
3. Locate the glass latches that are on the upper edge of
the glass frame of the appliance. See Figure 11.1.
4. Use both index ngers to release the glass clips.
5. Allow glass to tilt forward. Grasp glass on the upper
return lip of glass frame and lift up and out. The glass
should lift easily out of the bottom retaining lip.
Replacing Fixed Glass Assembly
1. Locate retaining lip on lower front face of rebox.
2. Place glass assembly into retaining lip end. Tilt top of
glass assembly toward replace.
3. Assure proper left to right placement of glass and en-
gage all four spring latches.
4. Replace bottom glass shield and decorative front.
B. Remove the Shipping Materials/Install
Bottom Glass Shield
Remove shipping materials from inside or underneath
the rebox. Verify all components are with the replace.
Unwrap the bottom glass shield and replace in the same
location as shown in Figure 11.2.
Figure 11.2 Bottom Glass Shield Location
BOTTOM GLASS SHIELD
GLASS CLIPS
BOTTOM RETAINING LIP
E. Install Log Set or Stones (Optional)
An optional log set and/or stones kit is available for use with
the ECHELON models. Install the accessories per instruc-
tions included with kit.
D. Install Glass Refractory (Optional)
An optional glass refractory kit is available for use with the
ECHELON models. Install the kit per instructions included.