Installation Manual

61
Majestic • ECHEL36IN/STIN, ECHEL48IN/STIN, ECHEL60IN, ECHEL72IN Installation Manual • 2406-970 Rev. C • 1/17
F. Install Media (Included)
A media kit is included for use with the ECHELON mod-
els. Install glass media as instructed. Use the chart
below to determine the amount of media to use for the
model size being installed. Three additional color options
are available for use with Echelon.
Cleaning the Media
During shipment of the media, dust and debris can
accumulate. It is recommended that the media be rinsed
thoroughly with water to remove dust and small particles.
An easy method to clean the media is to place the media
into a pail and rinse thoroughly. Spread the media out
over paper towels and allow the media to dry before
installing them into the fi replace.
WARNING
Delayed Ignition Risk
• Place media according to instructions.
• Do NOT place media in area in front of pilot
• Do NOT place media in a position that they may
fall into area in front of pilot.
• Do NOT place media in a position that pieces may
fall between the media tray and back of fi rebox.
• Do NOT use any media other than the Hearth
& Home Technologies-supplied options for this
fi replace model.
• Do NOT exceed one layer of media on base pan.
Fireplace will not function properly.
Delayed ignition may occur.
WARNING! Choking Hazard! Keep media out of reach
of children.
INSTALLATION
Note: If both the media and logs will be installed, the logs
must be installed fi rst.
1. Set aside a handful of media which will be used later to
conceal the pilot end of the burner.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during
installation. Sheet metal edges are sharp.
2. The media placement jig, shown in Figure 1, MUST
be used any time media are placed on the burner to
ensure that there is no media in the burner lighting area.
Verify that the media placement jig is correctly installed
in place in the appliance. See Figure 1.
CAUTION! Risk of Burns! The fi replace should be turned
off and cooled before media is installed.
Figure 1. Media Placement Jig Location
MEDIA
MEDIA
PLACEMENT JIG
PLACEMENT JIG
MODEL
MEDIA-MAX. #
OF BAGS
ECHEL36IN/ECHEL36STIN 3
ECHEL48IN/ECHEL48STIN 4
ECHEL60IN 6
ECHEL72IN 7
3. The media placement jig must remain in place while
media is placed on the media tray and around the pilot
bracket.
4. Place an even layer of media around the media tray as
shown in Figure 2. DO NOT place media on media
placement jig.
NOTICE: DO NOT EXCEED MAXIMUM AMOUNT OF
MEDIA. Place media as instructed. Flame performance
could be impacted. Sooting could occur.