Installation Manual

62
Majestic • ECHEL36IN/STIN, ECHEL48IN/STIN, ECHEL60IN, ECHEL72IN Installation Manual • 2406-970 Rev. C • 1/17
5. Remove the screw, noted in Figure 3, from the media
placement jig and carefully lift the jig out of the appliance.
DO NOT allow any pieces of media to fall into the
area in front of the pilot.
Figure 3. Remove Media Placement Jig
WARNING! Risk of Explosion! DO NOT place media
directly in front of the pilot assembly. Delayed ignition
could occur.
6. Place the media set aside in Step 1 over the pilot
shield and areas shown in Figure 4 uncovered by
removing the media placement jig. See Figure 4. DO
NOT allow any media in the 1 inch area shown in
Figure 5.
7. Check the pilot area to ensure there is no media
in between the end of the burner and the pilot.
Performance issues will occur if media is present.
WARNING! Risk of Explosion! DO NOT place media
between end of burner and pilot. Delayed ignition could
occur.
Figure 4. Media Installed with Media Placement Jig Removed
Figure 5. Pilot Shield Media installation.
MEDIA ALLOWED
MEDIA ALLOWED
ON PILOT SHIELD
ON PILOT SHIELD
NO MEDIA
NO MEDIA
ALLOWED
ALLOWED
APPROX. 1 IN.
APPROX. 1 IN.
SQUARE
SQUARE
8. DO NOT allow media to fall between the media tray
and the back of the fi rebox. Remove any fallen media
before proceeding. See Figure 6.
SCREW
SCREW
Figure 2. Media Placement Jig in Place
NO MEDIA ON JIG
NO MEDIA ON JIG
WARNING
Risk of Asphyxiation or Fumes.
• Place media according to instructions.
• Do NOT place media in area between glass and
fi rebox.
• Do NOT place media in a position that they may
fall into area between glass and fi rebox.
• Do NOT use any media other than the media
supplied with this fi replace.
Fireplace will not function properly.
Gas leak may occur.