Instruction manual

using the power cord provided with the power supply .

Avoiding Damage to the Instrument

1. Do not attempt to operate the device if it is damaged.

2. Protect this unit from physical damage, corrosive agents and extreme

temperatur es (direct sunlight etc).

3. For proper ventilation and safety c oncerns , keep at least 10 cm of space

behind the instrument, and at least 5 cm of space on each side.

4. Do not operate the power supplies in high humidity environments (> 95%),

or where conde nsation may occur.

5. When the power supply series is taken into a cold room environment, the

unit can be operated immediately. However, when the power supply series is

removed from the cold room environment, let the unit equilibrate to room

temperature fo r a minimum of 2 hours before using it.

6. Prior to apply any cleaning or decontamination methods other than

manufacturer ’s recommendation, users should check with the

manufacturer ’s instruction to confirm if the proposed method will not damage

the equipme nt.

Equipment Operation

Follow the guidelines below to ensure safe operation of the unit :

1. It must be checked the displayed figure to see if it is in the normal condition

for use before using this unit.

2. NEVER access dangerous chemistry or other mate rial to prevent possible

hazards of explosion and damage.

Symbols

The symbol s used on MS 250V / MS 300V Power Supply are explained below.

Used on MS Power Supply to indicate an area where a potential

shock hazard may exist.

Used on M S Power Supply to indicate a warning. Consult the manual

to avoid possible personal injury or instrument damage.

Used on MS Power Supply to indicate a disposal instruction.

DO NOT throw this unit into a municipal trash bin when this unit has

reached the end of its l ifetime. To ensure utmost protection of the

global environment and minimize pollution, please recycle this unit.