Instruction manual

4
Warning
The Minis power supply series has been tested and found to comply with the
limits for the CE regulation . Also, Minis power supply series is RoHS compliant
to deliver confident product, which meets the environmental directive. These
limits are designed to provide reasonabl e protection against harmful
interference when the equipment is operated in a commercial environment.
This power supply series generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this
power supply series in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at their
expense. Changes or mo difications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment. It is strongly recommended the user to read carefully the following
points before this equipment is operated.
1. Read and fol low carefully the manual instructions.
2. Do not alter the power supply series . Failure adhere d to these directions
could result in personal and/ or laboratory hazards, as well as invalidate
equipment warranty.
3. Use a properly grounded electrical outlet with correct voltage and current
handing capacity.
4. Disconnect from power supply before maintenance and servicing. Refer
servicing to qualified personnel.
5. In the event , solution is accidentally spilled into the instrument , disconnect
grounded plug and the user mu st carry out appropriate procedure or
contact Major S cience or the representative to replace damaged parts.
6. Do not use in the presence of flammable or combustible material; fire or
explosion may result. This device contains components, which may ignite
such materials.
7. Refer maintenance and servicing to qualified personnel.
8. Ensure that the system is connected to electrical service according to
local and national electrical codes. Failure to properly connect ion may
create fire or shock hazard.
9. Ensure the appropriate used materials and correct operation to avoid
possible hazards of explosion, implosion or release of toxic or flammable
gases arising from the materials being overheated.