Instruction manual

012-06263A Low Voltage AC/DC Power Supply

Specifications:

Outputs:

DC: regulated for both constant–voltage and con-

stant–current operation. Both current and voltage con-

tinuously variable over the range 0–24 V DC and 0–10

amperes maximum. Independent floating ground refer-

ence.

AC: 2 to 24 V (rms) AC, unregulated, selectable in

2–V increments, current up to 6 amperes. Output pro-

tected from overload by a 6-amp thermally-activated cir-

cuit breaker. Independent floating ground reference.

NOTE: Both DC and AC outputs are available

simultaneously on separate floating output terminals.

Either one of the DC output terminals can be con-

nected to either one of the AC output terminals to

form a composite signal without damage to the unit.

Equipment Specifications

Line Regulation:

Less than 1% change in DC output voltage or cur-

rent for full range change in line voltage. AC out-

put not regulated.

Load Regulations:

Better than 1% no-load to full-load on the DC out-

put voltage or current. AC output not regulated.

Ripple and Noise:

Less than 25 mV pp on DC output.

Metering:

DC voltage and DC current

Accuracy is +1% ± 2 L.S.D.

Line Voltage Requirement:

78–130 V AC, 60 Hz (model SF-9584A)

200–242 V AC, 50 Hz (model SF-9584A - 230)

Power Requirement:

DC and AC: Maximum 350 W

DC only: Maximum 175 W

AC only: Maximum 175 W

Fuse:

8 A Slo-Blo—(model SF-9584A)

4 A Slo-Blo—(model SF-9584A-230)

Size:

118 x 298 x 229 mm (H x W x D including controls)