Instruction manual

12
*To set constant current, press , and LED indicator should light up.
6. Adjust the output value by pressing the or button.
7. After adjusting your constant mode output value, switch to the other
parameter and set it to maximum.
8. Timer Setting: After setting the current or voltage output value, press the
Timer button, and then press key or key to adjust timer
accordingly.
Note: When timer is set as “0”, it means continuous operation.
9. Press Key to start the run. Once the electrophoresis starts, the LED
light next to the button will light up.
10. Press Key again to stop the unit at any time if necessary.
11. When the run is completed, Press Key to terminate a timed run, and
Turn the AC power OFF by the switch on the rear.
12. The programmed settings will be automatically saved into the system so
the next time you turn it on, the same settings as your previous experiment
will be displayed.