User Manual


Ensure that the power supply voltage is within the range of 110V -240V ~ 50Hz/60Hz. Any other
voltage may cause damage to the unit.
The Sierra Plus comes with a power adapter for the soundbar. Make sure to unwind the cable to its full length.
Connect the plug to a mains socket by fully inserting the plug into the mains socket.
Connect the adapter to the AC power port in the back of the soundbar (Back View Ref.6).
The display panel will show ‘–‘ to indicate it has registered a power source and is on standby mode.
Press the ‘POWER’ button on the remote control (Remote Control Ref.1) or press and hold the ‘POWER’
button for 3 seconds on the top of the soundbar (Front and Top View Ref.2) to turn the unit on or off.
Connecting the Soundbar and Wireless Subwoofer

Please note: The soundbar and subwoofer must be within a 10 metre range of each other in
order to be successfully connected.
The subwoofer and soundbar will wirelessly connect for a surround sound experience. This allows you to
place the subwoofer in the corner of the room to ensure that the sound from your TV lls the room.
To connect them, please ensure that your soundbar is switched on for the initial setup. To do this, press the
‘POWER’ button (Front and Top View Ref.2) on the unit or the ‘POWER’ button on the remote control (Remote
Control Ref.1).
The subwoofer has an indicator light (Subwoofer Back View Ref.1)- this will ash when looking for a
connection, and show a solid light when connected.
The subwoofer and soundbar should then automatically connect using a wireless Bluetooth connection.
If you are having connectivity issues, please move the subwoofer closer to the soundbar for setup. If this
does not work, please press and hold the PAIR button (Subwoofer Back View Ref.2) to reset the connection
between the subwoofer and the soundbar.
Using the RCA Audio Cable