Operation Manual

NOTE: For best results, prevent twisting the probe cable, exposing it to high heat or
direct flame, or immersing it in water. To clean, wipe the probe with a damp cloth with
mild detergent. The probes should only be used to monitor internal meat temperatures,
not your grill's cooking temperature. Store probes in a dry place away from water or
moisture.
Screen Display-TIMER
Description:
Settings:
Screen Display-ELAPSED TIMER
Description:
Settings:
Screen Display-USER PROGRAM
Description:
The TIMER can be set to count down and alarm when it
reaches zero. It will reset to zero whenever the grill is turned off.
Press and hold the STAR button for 3 seconds. The MINUTES
will flash. Using the UP or DOWN arrow buttons, set the minutes from 01
to 59. To set HOURS, press the LEFT or RIGHT arrow button. The
HOURS will now flash. To set hours, use the UP or DOWN arrow buttons
to select the number of hours you want. Once the hours and minutes are
set, press the STAR button to lock in. Press the STAR button once more
to activate or pause the timer.
When the timer reaches zero, an alarm will sound and the display screen
will flash until any button on the control panel is pressed. When the grill is
turned off, all alarms will reset to OFF. Press and hold the STAR button
for (3) three seconds to reset the timer back to zero.
The Elapsed Timer keeps track of the total amount of
cooking time. When activated, the timer counts-up both hours and
minutes. The timer will reset to zero whenever the grill is turned off.
Press the STAR button to start the Elapsed Timer. Press the
STAR button again to stop the timer. To reset to zero, press and hold the
STAR button for (3) three seconds.
There are (3) three User Programs available for use. Set-up
and operation of each User Program will be the same. Each program
allows you to make up to (5) five cooking steps, which will automatically
change from one step to the next based on either time or meat probe
temperature. Note: You can only use (1) one User Program at a time.
Once a program is set, it will remain until you change it.
To set up any USER PROGRAM, use the Left or Right ARROW buttons
to select USER PROGRAM 1, 2 or 3.
Press the STAR button---the word OFF will flash.
Use the Up or Down ARROW buttons to reach SETUP.
Press the STAR button again. The screen will now display STRT 1.1
SET:SMKE. Use the UP or DOWN arrow buttons to select your desired
starting temperature.
?
?
?
?
12