Owner`s manual

MAK GRILLS Owner’s Manual • Pellet BBQ Smoker-Grill • Model EP-429-2G

ALARMS

MANUAL

IGNITING PELLETS

Description:

Settings:

Description:

Settings:

Description:

When ALARMS are set and reached, the unit will beep and

the appropriate screen will flash. The alarm will sound for (10) ten minutes

before automatically shutting off.

To end the alarm, push any button on the control panel. See

individual screen settings for turning ALARMS on and off.

To silence all audible ALARMS on the Pellet Boss:

To entirely shut off all audible ALARMS on the Pellet Boss, use the

arrow keys.

Push SELECT for 10 seconds until MAKGRILL Ver. 1.6 (or higher) is

displayed.

Press the arrow key until you reach ALARM ENABLED.

Press SET

Use arrow key to select ALARM ENABLED or ALARM SILENT

Press and hold SET to return to normal display screens

MANUAL MODE is designed as a back-up in case of a

thermocouple failure. If your thermocouple fails, the unit will not be able to

detect the actual grill temperature. Therefore the grill will not function

properly. In this case you will have to enable the manual mode if you

choose to operate your grill until a new thermocouple is installed.

MANUAL mode is a timed sequence so grill temperatures will vary.

To enable the MANUAL MODE press and hold the SET button

for 10 seconds. Once enabled, you can set the grill temperature from the

following options; SMOKE (175), LOW (225), MEDIUM (275), MEDHIGH

(350) & High (450+). To change the temperature setting for the grill press

”SET”, the temperature will flash. Use the arrow buttons to adjust. When

finished press ”SET” again. The temperature will stop flashing and the grill

will adjust to the new set temperature. Note: Because there is no working

thermocouple, the screen will not show the grill temperature. To return to

the NORMAL MODE press and hold the SET button for 3 seconds.

This screen will activate whenever the igniter rod is on. The

screen will also activate in the case of an “auto relight sequence” which

initiates if the fire in the firepot has gone out. IGNITING will show on the

display screen and the grill will repeat the lighting sequence three (3)

times before shutting the grill off and displaying “FLAME OUT, CHECK

FIREPOT, CHECK HOPPER”.