Owner`s manual

MAK GRILLS Owner’s Manual • Pellet BBQ Smoker-Grill • Model EP-429-2G
22
PROBLEM
ACTION TO TAKE
Auger Is not Turning
Fan Does Not Run
For any additional operation issues not covered in this guide,
please contact your local MAK GRILLS DEALER. You may also
phone us at [phone] between 9AM-4:30 PM, Monday-Friday,
Pacific Time. You may also contact us via email:
[e-mail]
?
?
If the pellets have jammed your auger,
you will need to remove the auger and
clean out the auger and auger tube.
This can be done by removing pellets out
of the hopper and removing the firepot.
Use a shop-vac to suck out as many of
the pellets from each end of the auger
tube. Remove the back panel, fan, and
fan deflector. Unplug the auger from the
circuit board. It is labeled AUGER.
Remove the two (2) auger mounting
screws from the rear of the motor and pull
the auger out through the back of the unit.
Clean out any remaining wet pellets or
dust from the auger, auger tube and
surrounding areas. Replace auger in
reverse order and test to see if auger
turns before adding new pellets.
Never put spilled pellets from the
ground back into your pellet hopper.
?
?
?
Check the fuse located on the front of the
control board to make sure it has not
blown.
The fan should run any time the power is
turned on. If the fan is not turning,
Disconnect from power, remove the
fan/access panel to get to the back of the
control board. Make sure that the plug
labeled FAN is tightly connected to the
back of the control board.