Owner manual

Connecting 2 Analog Memory to 2

Pressure Points

Connect one of the remaining 3 connectors to the 10 pin header on

the Pressure Points that is marked “EXPND.” You will need to re-

move all 4 of the small black “jumpers” that are covering the pins of

this header before you attach the EXPAND CABLE. Maintain proper

orientation of the cable, keeping the Red Stripe DOWN. Connect

each Analog Memory to the Pressure Points with which you wish to

control it.

Now connect the EXPAND Cables to the 10 pin headers on the

BRAINS marked “Points 1-4” and “Points 5-8.” The EXPAND Cable

coming of the Pressure Points nearest to the BRAINS is connected

to the “Points 1-4.”

Using the provided CHAIN cable, connect the two Analog Memory

modules at the 10 pin header marked “CHAIN.” Maintain proper ori-

entation of the cable, keeping the Red Stripe DOWN at both ends.

Analog Memory(s) that are not the that last in the CHAIN will need

to have the jumper marked “Close 4 Master” removed.

Please see the Pressure Points and BRAINS manuals for details on

proper jumper settings and connection for Pressure Points/ BRAINS,

and follow those instructions.

NOTE: Power Cables removed in photo for clarity.