User manual

15
[press] PGM_A and PGM_B
To begin Phase Programming,
+
+
Once in the Phase Programming Page:
[Hold] PGM_A
For Coarse Phase decrement:
[TAP] Associated
Buttons)1-6
one to four times
[TAP] Associated
Button(s)1-6
one to four times
For Coarse Phase increment:
[Hold] PGM_B
Hold PGM_A and tap the associated Channel Button(s) 1-4
times in order to Coarse Phase Program its Output(s). Coarse
Phase adjustments oset the Phase of the Channel's Output
by one cycle of the Leading Tempo. The State LED lights red
to indicate a Coarse Phase decrement has been made.
Hold PGM_B and tap a Channel Button(s), (1-4) times in order
to Program the associated Channel Output(s). Coarse Phase
adjustments oset the Phase of the Channel's Output by one
cycle of the Leading Tempo. The State LED lights green to
indicate a Coarse Phase increment has been made.
When programming Multiples of the Leading Tempo, Coarse Phase adjustments can be very subtle. Here is why: if the Channel is
set to an integral Multiple (e.g. * 4), Coarse Phase will have no audible eect, because the Channel's Clocks are output at the same times at
each pulse of the Tempo. If the Channel is set to a non-integer Multiple (e.g. * 4.25), the Channel's clocks will drift in and out of Phase with
the Leading Tempo over a period of several pulses of the Tempo. Coarse Phase of a Multiple in this situation only aects the zero-center
of this Phase-shifting: a subtle eect.
Machine Programming : Phase
The other way to Machine Program is by making Phase
adjustments. To enter the Phase Programming Page, press
PGM_A and PGM_B at the same time. While in the Phase
Page, both PGM_LEDs are on. State changes and Human
Programming are ignored. To exit, press both PGM_A and
PGM_B.
Next, Phase adjustments are performed in a similar way to
the Multiplier/Divisor settings using Coarse and Fine Phase
increments and decrements.