User manual

21
While on the Program Edit Page, Button-6 sets the behavior of the Mod Input jack for Shift and Reset behaviors
to be Jumbled or Unjumbled.
New to v.31
New to v.31
Run/Stop and Shift
Button-4 and 5 = Red
Jumbled Button-6 = Red
Any Phase O set changes created by Run/Stop messages will be preserved when navigating away from and back to a given
State. Phase O set changes are not saved upon power cycle.
Unjumbled Button-6 = O
Any Phase O set changes created by Run/Stop messages will NOT be preserved when navigating away from and back to a given
State.
Run/Stop and Shift
On the Program Edit Page, Run/Stop and
Shift can both be enabled at once.
The State Select Gate Input is used to Shift Variable Clock
Values (see page 19) while the Mod Input is used for
Programming Run/Stop behavior (see page 20).
Note: If both Shift and Run/Stop are both enabled, all
State selection must be done using the State Select CV
and Combo Pot.
Progam Edit: Run/Stop (cont’d)
Jumbled
Button-6 = Red
Unjumbled
Button-6 = O