User manual

30
Patch Ideas
Clock Murmur:
Patch an Output of the Tempi to Rene’s X-CLK input to start the sequence. Make sure Snake Mode is engaged via the X-Fun Page.
Now, patch from Rene’s X-Gate Output back into TEMPI’s Tempo Input. Back on Rene, migrate to the X-Gate page and remove
every other gate on the top two rows, as illustrated in the chart below. This feedback loop causes the TEMPI to hickup slightly
every time the Gates driving the Leading Tempo change from half-time to 1:1 and back. (Recall: it takes two clock pulses in order
for TEMPI to program a new Leading Tempo). To best hear this eect, use one or more of the TEMPI’s Outputs to Strike a Low Pass
Gate like the Optomix or LxD.
1:1
TEMPI Transposition
Patch one of TEMPI’s Outputs programmed 1:1 with the Leading Tempo to Rene’s X-CLK input to start the sequence. Patch Rene’s Qcv
Output to the Signal Input on ModDemix Channel 1. Next, patch another TEMPI Output programmed to ÷16 to ModDemix’s Aux Input.
With Channel 2’s attenuverter full counter clockwise, patch from ModDemix’s SUM Output to the 1V/Oct input of an oscillator like the STO
in order to sequence it’s pitch. The Channel 1 attenuverter sets the degree of the transposition.
1:1 1:1
1:11:1 ÷16