User manual

5
-12V
Electrocution hazard!
bus board connection cable.
Do not touch any electrical terminals when attaching any Eurorack bus board cable.
The Make Noise TEMPI is an electronic music module requiring 46 mA of +12VDC regulated voltage and a
properly formatted distribution receptacle to operate. It is designed to be used within the Eurorack format
modular synthesizer system.
Go to http://www.makenoisemusic.com for examples of Eurorack Systems and Cases.
eurorack bus board connector cable on backside of module (see picture below), plug the bus board
connector cable into the Eurorack style bus board, minding the polarity so that the RED stripe on the cable is
oriented to the NEGATIVE 12 Volt line on both the module and the bus board. On the Make Noise 6U or 3U
Busboard, the NEGATIVE 12 Volt line is indicated by the white stripe.
To install, nd 10HP in your Eurorack synthesizer case, conrm proper installation of inlcluded
Please refer to your case manufacturers’ specications for location of the negative supply