Datasheet
RB-Mab-76
Makeblock Me PIR Motion Sensor
Me PIR sensors are used to detect motion from animals/ humans from about 6m away. If anyone
moved in that range, the sensor outputs HIGH on its SIG pin. With a potentiometersoldered on its
circuit board, you can adjust its detecting range according to your need. Here are some ideas for
application: motion detecting, thief-guarding system, automation switch.
Note: when you give it power supply,you may need to wait 10 seconds until the sensor Initialize.
Features
• Adjustable detecting range and high sensity
• A power indicator LED(Red) and a state indicator(Blue)
• 16mm interval M4 mounting holes, compatible with Makeblock beams
• 2.54mmbreakout pins for connecting with jumper wires
• Easy wiring with 6 Pin RJ11 interface
• Arduino library for easy programming
Specifications
• Rated Voltage: 5V
• working temperture:-20℃~+70℃
• Level output voltage: 5V/high, 0V/low
• Trigger signal: 5V/high
• Holding time: 2s
• Detecting angle: 120 degree
• Detecting distance: max 6m
• Size:24x48x 32mm(Length x Width x Height)