User manual

Makeblock Music Robot V2.0 User Guide
www.makeblock.com
34/40
Figure 52
2.Choose the type of your Arduino board, you can figure out by checking the back of
your Arduino board. Here we use Arduino Uno as example.
Figure 53
3.Click the “Connect” , and click “Upgrade”, the firmware will update. (A stable network is
required.)
Figure 54
4. After updating, Music Robot Kit V2.0 will keep moving until reach the Me Limit Switch
Sensor V2.0. When it touch the limit switch, it will move back a short distance and hit the
first note. At the same time, the first LED RGB Strip will turn on. Stay for 3 seconds,
Music Robot will play “Brother John” and it will stop play when the music is finished. You
can control the Music Robot by 2 ways: Using gestures or up-computer.