User's Manual

Page 4 of 13
Safety Instructions
Please read through the following before using printer:
1. Safety Warnings
Warning: printer head is heating part, so please don't touch it and its surrounding
parts during and after printing.
Warning: don't touch the printer head and connector to avoid damaging it due to
static electricity.
2. Notes
1) Reserve enough space around the printer for the convenience of operation and
maintenance.
2) Keep the printer away from water.
3) Don’t use and save the printer in the high-temperature, high-humidity and seriously
polluted place. Moreover, avoid direct exposure to sunlight, glare and heat sources.
4) Avoid placing the printer at the place where there is vibration and impact.
5) Don’t allow moist air to form condensation on the printer's surface. If any, don’t turn on
the printer until the dew has disappeared.
6) Connect the printer's power adapter to an appropriate grounded socket. Don't share the
same socket with a large motor or other devices that can cause fluctuation in the power
supply voltage.
7) If you do not use the printer for a long time, please disconnect its power supply.
8) Please turn off the power if water or any conductive material (such as metal) gets into
the printer.
9) Don’t use the printer if no card, otherwise it will seriously damage the rubber roller and
printer head.
10) For connecting or disconnecting ports, turn off the power, otherwise damage the control
circuit of the printer.
11) If the printing effect meets operating requirements, you are recommended to set a low
printing density as far as possible to avoid affecting service life of printer head.
12) Don't disassemble the printer by yourself for repairing.
13) The User Manual shall be kept properly for reference.