User's Manual

Page 3 of 12
Safety Instructions
Please read through the following before using printer:
1. Safety Warnings
Warning: print head is heating part, so please don't touch it and its surrounding
parts during and after printing.
Warning: don't touch the print head and connector to avoid damaging it due to static
electricity.
2. Notes
1) Reserve enough space around the printer for the convenience of operation and
maintenance.
2) Keep the printer away from water.
3) Don’t use and store the printer in the high-temperature, high-humidity and seriously
polluted place. Moreover, avoid direct exposure to sunlight, glare and heat sources.
4) Avoid placing the printer at the place where there is vibration and impact.
5) Don’t allow moist air to form condensation on the printer's surface. If any, don’t turn on
the printer until the dew has disappeared.
6) Connect the printer's power adapter to an appropriate grounded socket. Don't share the
same socket with a large motor or other devices that can cause fluctuation in the power
supply voltage.
7) If you do not use the printer for a long time, please disconnect its power supply.
8) Please turn off the power if water or any conductive material (such as metal) gets into
the printer.
9) Don’t use the printer with no media installed, otherwise the rubber roller and print head
may get damaged.
10) For connecting or disconnecting ports, turn off the power, otherwise the control circuit of
the printer may get damaged.
11) To prolong service life of print head, it’s recommended to set a low printing density
whenever printing quality is fine.
12) Don't disassemble the printer by yourself for repairing.
13) The User Manual shall be kept properly for reference.