M2 Assembly Guide 2_0

ManualsBrandsMaker Made ManualsRoboticsM2 Automated Cutting Machine Kit

M2 ASSEMBLY GUIDE

4. Attach the motor mounts on each edge of the top

beam, flush with the ends. Use one D1 screw on front

and four on top.

5. Place motor in left bracket, with cylindrical end

toward center. Slide lock E4 washers over E3 screws

and fasten screws through the front of the motor with a

Phillips Screwdriver.

6. Attach E1 motor sprocket by inserting the E2 grub

screw into the gear hole, aligning with the flat side of

the motor shaft, and tightening with E5 Allen wrench to

prevent slipping.

7. Repeat steps 5 and 6 to mount the motor on right

side.

1. Measure the distance from the ground to the bottom of the stud mount. Attach the other wasteboard stud

mount to the stud on the opposite side at the exact same height.

2. Lean your wasteboard against the stud mounts and arrange it until it is level across the top. Clamp the

wasteboard to the stud mounts and mark 10” up from the top of your wasteboard on the wall above each

stud mount. This will be where the bottom of the top beam stud mounts will attach to the wall and ensure the

required 18” distance between your wasteboard top edge and the top of the to be installed motor sprockets.

3. Measure and mark the exact middle of the 10’ top beam. Repeat on your wasteboard. Then measure how far

the wasteboard stud mounts are from its center. Mark the equal distance on your top beam, to ensure your top

beam will be centered with your wasteboard. Attach the stud mounts to the 10’ top beam with D1 screws and

a speed square. Ensure that they are the same distance up from the bottom of your beam, and the larger end is

placed to be closest to the ground. Pilot holes that are 0.5” from the bottom edge can help.

BUILDING YOUR FRAME PART 2: BUILDING THE TOP BEAM AND ADDING THE X/Y MOTORS (BAG D, BAG E)

92 "

Step 1: Attach Stud Mounts to wall

" up from floor

(a) Find stud and attach

first Stud Mount using 2pcs

long wood screws in Bag D

(b) Attach Stud Mount

using 2 drywall anchors

and

2pcs long wood

screws in Bag D

Step 2: Mount Top Beam to Stud Mounts on wall

ASSEMBLY GUIDE

Use 8pcs short wood screws in Bag D to attach top beam

Step 3: Attach last two Stud Mounts

146mm [5.75in]

Stud Mounts directly below

first Stud Mounts