M2 Assembly Guide 2_0

M2 ASSEMBLY GUIDE

1. Using included B2 screws, mount the control board in its case to the wall behind Wasteboard, helps to mount

in middle for motor wires to reach.

Drew’s Note: If you’re mounting without case or need to modify for any reason, this is how to attach the top Control Shield to

bottom DUE board. Line up the pins as shown and be careful they don’t bend

BUILDING YOUR FRAME PART 6: MOUNT AND CONNECT ARDUINO DUE BOARD AND SHIELD

Drew’s Note: The M2’s brain is an Arduino DUE microcontroller. We recommend mounting the DUE to the wall behind your

Wasteboard, but it can be mounted in any safe location where it won’t be stepped on or conflict with the M2 during operation.

With case, wire plugs on bottom.

Bottom DUE board, without case (notice how the

“DUE” written on the board is up). That is the

orientation for this instruction, the bottom power

is unused.

Pin Alignment Bottom View Top View

This work is licensed under the creative commons Attribution

Non Commercial-No Derivatives 4.0 International license. Last Updated 1.18.2021

Version 2.0