Manualshelf

M2 Assembly Guide 2_0

ManualsBrandsMaker Made ManualsRoboticsM2 Automated Cutting Machine Kit
29303132333435363738
32
M2 ASSEMBLY GUIDE
9. CONNECT M2 TO WORKSPACE
You are now in your M2 Workspace! Click “Open” to connect your M2.
10. CALIBRATE
When you connect a new machine, you need to calibrate it to your frame. Click “Yes” to start
the calibration and follow the onscreen steps!
Drew’s Note: When connecting your M2 for the first time, be sure to be close to a power source to unplug if
anything does not go as planned.
If the X, Y, and Z motors are not plugged in completely to the motors and Arduino DUE Board, the M2 will not
follow your commands and will act wonky (like continuing to move when you only told it to move 1 inch).
This work is licensed under the creative commons Attribution
Non Commercial-No Derivatives 4.0 International license. Last Updated 1.18.2021
Version 2.0