M2 Assembly Guide 2_0

M2 ASSEMBLY GUIDE

2. START:

Before you cut, raise the Z-Height 3mm above your print surface (so it doesn’t start touching

your material). Put on safety goggles, set your router RPM to the recommended cut speed

for the material, manually turn on your router so your bit is spinning, and click the green

“Run” button to begin cutting out your project! We recommend running the first cut with the

Drew’s Note: When your M2 is cutting for the first time, be close to the power source to stop all operation if

something goes awry. After your first cut, you should measure and compare the real values of your square

cut to the values of your Gcode for scaling. Be sure that you set easel’s cut path around the outside of your

square, so you can have the correct measurement from the inside edge to inside edge.

3. PAUSE/STOP

To pause or stop the M2, click the “Pause” button on the top bar. Once the M2 is paused,

you will be able to stop the project by clicking the “Stop” button next to it. It must be paused

before you can stop the project!

This work is licensed under the creative commons Attribution

Non Commercial-No Derivatives 4.0 International license. Last Updated 1.18.2021

Version 2.0