User manual

TROUBLESHOOTING
75
Error Message Description
Something might be wrong with your
extruder. Please visit makerbot.com/
support/new/support to learn what your
support options are.
This is just an informational message. If
you are loading or unloading filament, the
process times out aer five minutes.
The onboard preheat sequence was
interrupted by instructions sent by the
soware telling the MakerBot Replicator
2X to change the extruder temperature.
These are the messages you could receive
if your SD card is not formatted correctly
or if there is something wrong with the
card. Your MakerBot Replicator 2X can
read SD cards:
• formatted for FAT16 SDSC card
• no larger than 2GB.
Make sure your SD card has not been
removed from the MakerBot Replicator
2X during printing. If the card is still in its
port on the MakerBot Replicator 2X, there
might be a problem with the card itself.
Make sure the card is formatted correctly.
LCD ERROR MESSAGES CONTINUED