User manual

TROUBLESHOOTING
77
5. Look closely at your test print. First look at the set of lines to the le [the lines that are
parallel to the front of the build plate]. Notice that the first lines on the le are farther
from the front of the build plate than the first lines on the right. Examine the lines and
find the pair of lines that match best. The best match will look the most like a single
continuous line, with both test lines perfectly centered. Note the number. This is the
best line for the Y axis.
6. Look at the set of lines to the right [the lines that are perpendicular to the front of the
build plate]. Examine the lines and find the pair that match best. The best match will
look the most like a single continuous line, with both test lines perfectly centered.
Note the number. This is the best line for the X axis.
7. The LCD menu will prompt you to enter the line number that is best for the X axis and
the line number that is best for the Y axis.
8. Use the arrow buttons to select a line number and the M button to select a line
number. The MakerBot Replicator 2X will store this information about the locations of
the extruder nozzles and use them to make future prints align better.
MISALIGNED NOZZLES CONTINUED