User manual

WELCOME
9
SAFETY AND COMPLIANCE CONTINUED
Safety alert symbols precede each safety message in this manual.
These symbols indicate potential safety hazards that could harm you
or others or cause product or property damage.
WARNING: The MakerBot Replicator 2X Experimental 3D Printer
generates high temperatures. Always allow the MakerBot Replicator 2X
to cool down before reaching inside.
WARNING: The MakerBot Replicator 2X includes moving parts that
can cause injury. Never reach inside the MakerBot Replicator 2X while
it is in operation.
WARNING: Do not leave the MakerBot Replicator 2X unattended
during operation.
CAUTION: Use caution when printing with materials that have not been
approved by MakerBot for use with the MakerBot Replicator 2X.
CAUTION: In case of emergency disconnect power supply from
wall socket.
CAUTION: The socket outlet must be located near the equipment and
must be easily accessible
CAUTION: The MakerBot Replicator 2X melts plastic during printing.
Plastic odors are emitted during this operation. Make sure to set up the
MakerBot Replicator 2X in a well-ventilated area.