User Manual

- 12 -
5.4 The PLA print nozzle temperature is 190-220, and the ABS
print nozzle temperature is 210-230. The printing temperature
required for the consumables fluctuates. If the wire is not
smooth, you can try to increase the printing temperature (such
as 200 to 205 or 210 printing) and try to increase the
temperature by 5-10 degrees.
6. What parts of the 3D printer should be routinely maintained?
First, before starting the 3D printer printing every day,
you should carefully check whether the nozzle is blocked or
damaged, whether the connection lines of each part are normal,
whether the motor bearings and guide rails are short of oil,
and whether the platform is calibrated. If there is any
retentate in the nozzle, it should be cleaned up immediately.
If the part is damaged or aged, it should be replaced in time.
Regularly add lubricating oil to the moving parts, and the nut
should be tightened if it is loose.
Secondly, during the printing process of the 3D printer,
the parameter settings should not exceed the limit of the
device. Otherwise, the qualified product cannot be printed.
If the temperature is too high or the load is too large, the
device may be damaged. There is also a place where something
is wrong during the printing process. If necessary, stop the
machine. Do not let the device continue to work if you want
to reprint because of the downtime.
Finally, clean the work after printing is complete. The
dirt on the nozzles, platforms, guide rails, motors, fans, etc.
of the 3D printer should be cleaned up. Do not accumulate for
a long time and cause the last bad cleaning.