Use and Care Manual

Page 19 of 54
OPERATING YOUR PRESSURE WASHER
1. How to Pre-start your pressure washer
To start your pressure washer for the first time, follow these instructions. This
information also applies if you let the pressure washer sit idle for at least a day.
1.1 Place pressure washer near an outside water source capable of supplying
water at a flow rate at least 5 gallons/19L per minute and no less than 20 psi
at pressure washer end of garden hose.
1.2 Check all high pressure hose connections are tightly connected to the pump,
valve, spray gun and Roto-Clean.
1.3 Make sure there are no kinks on hoses
1.4 Make sure the unit is in a levelled position.
2. Attaching High pressure hose to spray gun
2.1 The spray gun is preassembled to a swivel M22 Male nipple.
2.2 Connect the M22 female twist knob from the high pressure hose to the
spray gun as shown by hand, make sure it’s a tight fit and the threads
are not cross threaded (the connection is a self-sealed one, hence no
plumbing is needed)