Planer User Manual

FUNCTIONAL DESCRIPTION
Installing or removing battery cartridge
*Always switch off the tool before inser-
tion or removal
of the battery cartridge.
*To remove the battery cartridge, withdraw
it from the tool while pressing the buttons
on both sides of the cartridge.
*To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip
it into
place. Always insert it
all the way until it
locks in place with a little click. If not, it
may accidentally fall out of the tool, caus-
ing injury to you or someone around you.
*Do not use force when inserting the battely cartridge. If the cartridge does not slide in
easily, it is not being inserted correctly.
Charging
*Your new battery cartridge is not charged.
You will need to charge it before use. Use
the high capacity battery charger Model
DC1411 to charge the battery cartridge.
*Plug the high capacity battery charger into
the proper A.C. voltage source. The charg-
ing light will flash in green color.
*Insert the battely cartridge
so that the
plus and minus terminals on the battely
cartridge are on the same sides as their
respective markings on the high capacity
battery charger. Insert the cartridge fully
into the port
so that it rests on the charger p 'C irt floor.
*When the battery cartridge is inserted, the charging light color will change from green to
*When the charging light color changes from red to green, the charging cycle is complete.
*If you leave the battery cartridge in the charger after the charging cycle is complete, the
charger will switch into its "trickle charge (maintenance charge)" mode which will last
approximately 24 hours.
red and charging will begin. The charging light will remain lit steadily during charging.
*After charging, unplug the charger from the power source.
9