Specifications

12
Guide rule
The handy guide rule allows you to make accurate straight
cuts parallel to a straight edge of a workpiece. Loosen the
wing bolt which secures the guide rule. Align the appropriate
arrow on the scale plate with the cutting line. Move the guide
rule until it contacts the side of the workpiece. Tighten the
wing bolt to secure the guide rule.
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection or
maintenance.
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take out
the worn carbon brushes, insert the new ones and secure
the brush holder caps.
To m a int ain p rod uct S A FE T Y an d R EL I ABI LIT Y, r e pa i rs, a n y
other maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always using
Makita replacement parts.
1. Wing bolt
2. Scale plate
3. Cutting line
4. Guide rule
1
2
3
4
004836
1. Limit mark
1
001145
1. Screwdriver
2. Brush holder cap
1
2
004837