Specifications

6
Installing or removing abrasive belt
Loop the belt over the front pulley. Hold the tool as shown in the figure and
press down to retract the front pulley so that you can slip the other end of the
belt over the rear pulley. When pressing down the tool, be careful not to allow
the front pulley to turn unexpectedly, causing you to lose control of the tool.
NOTE:
The arrow on the inside of the belt and that marked on the rear pulley
must point in the same direction.
Connecting to Makita vacuum cleaner
CAUTION:
Always close the nozzle cap when the vacuum cleaner is not connected
to the nozzle. Never insert your finger into the nozzle.
Cleaner sanding operations can be performed by connecting the belt sander to
Makita vacuum cleaner.
When connecting to Makita vacuum cleaner, an optional hose 28 mm in inner
diameter is necessary.
1. Rear pulley
2. Front pulley
1
2
001285
1. Arrow
1
001286
1. Nozzle cap
2. Nozzle
1
2
001287
1. Nozzle
2. Hose 19
3. Hose of vacuum cleaner
4. Vacuum cleaner
1
2
4
3
001288