User Manual

11
english
MAKITA 447 L
‡ Reduced suction power > Suction power selected with
suction power controlis to
low.
> Clogged suction hose/noz-
zle.
> Seal/tank rim between the
upper section of the cleaner
and the dirt tank is dirty/de-
fective.
> Disposal bag full.
> Filter element is clogged.
• Set suction power in ac-
cordance with section 4.2.3.
"Suction power control".
• Clean suction hose/nozzle.
• Clean/replace seal.
• See section 7.2.2 "Re-
placing the disposal bag".
• See section 4.3 "Clean-
ing the filter element" and
7.2.3 "Replacing the filter
element".
‡ No suction power during wet
cleaning
> Tank full. • Switch off the cleaner.
Empty the tank.
‡ Voltage fluctuations > Impedance of power supply
is too high.
• Use a suitable extension
cord (see section 9.4 "Tech-
nical data").
• Connect the cleaner to
another socket closer to
the fuse box. Voltage fluc-
tuations over 7 % should not
occur if the impedance at
the transfer point is b 0.15 7.
Fault
Cause
Remedy
> Cleaning device failure • Connect Makita Service.
9 Further information
9.1 Recycling the vacuum
cleaner
Make the old cleaner unusable
immediately.
1. Unplug the cleaner and cut
the power cord.
Do not dispose electrical ap-
pliances as unsorted domestic
waste.
In accordance with European
guideline 2002/96/EG on Waste
Electrical and Electronic Equip-
ment all used up electrical appli-
ances must be collected sepa-
rately and supplied to a environ-
mentalfair recycling.
Contact your local authorities or
your nearest dealer for further
information.