ENGLISH (Original instructions) INSTRUCTION MANUAL Circular Saw 5901B 5902B 004126 DOUBLE INSULATION IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model 5901B Blade diameter Max. cutting depth 5902B 235 mm at 90° 85 mm at 45° 60 mm at 50° 53 mm No load speed (min-1) 4,100 Overall length 380 mm Net weight 7.4 kg Safety class /II 6.8 kg /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country.
must be repaired. Disconnect the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally. 21. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of untrained users. 22.
or loss of control. • A typical illustration of proper hand support, workpiece support, and supply cord routing (if applicable). 000157 5. 6. 7. 8. 9. • Hold power tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will also make exposed metal parts of the power tool "live" and shock the operator. When ripping always use a rip fence or straight edge guide.
10. 11. 12. 13. 14. produce narrow kerf causing excessive friction, blade binding and kickback. • Blade depth and bevel adjusting locking levers must be tight and secure before making cut. If blade adjustment shifts while cutting, it may cause binding and kickback. • Use extra caution when making a "plunge cut" into existing walls or other blind areas. The protruding blade may cut objects that can cause kickback. Check lower guard for proper closing before each use.
WARNING: Fig. 2 DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. FUNCTIONAL DESCRIPTION • 000150 20. 21. Before setting the tool down after completing a cut, be sure that the lower guard has closed and the blade has come to a complete stop.
Removing or installing saw blade Sighting 1. Base plate B 1. Shaft lock 2. Wrench A 1 1 2 004129 004131 For straight cuts, align the A position on the front of the base with your cutting line. For 45° bevel cuts, align the B position with it. CAUTION: Be sure the blade is installed with teeth pointing up at the front of the tool. • Use only the Makita wrench to install or remove the blade.
Joint set (optional accessory) 1 1. Rear handle 2. Front grip 3. Base 2 3 004136 Rip fence (Guide rule) 004134 Attach the joint to the chip chute in the blade case and secure it with the screws. Remove the lever attached to the main unit and attach lever of joint set. 1 1. Screw 2. Rip fence (Guide rule) 2 004137 The handy rip fence allows you to do extra-accurate straight cuts.
secure the brush holder caps. 1 1. Brush holder cap 2. Screwdriver 2 004138 To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons.
Makita Corporation Anjo, Aichi, Japan 884289C6 12 www.makita.