Instruction manual
Specific Safety Rules
USBO22-1
1.
Hold
tool by insulated gripping surfaces when performing an operation where
the cutting tool
may
contact hidden wiring. Contact with
a
"live" wire will
also make exposed metal parts
of
the tool "live" and shock the operator.
2.
Be aware that this tool is always
in
an operating condition, because
it
does
not have to be plugged into an electrical outlet.
3.
Always be sure you have a firm footing.
4.
Be sure no one is below when using the tool
in
high locations.
5.
Hold the tool firmly.
6.
Keep hands away from rotating parts.
7.
Do
not leave the tool running. Operate the tool only when hand-held.
8.
Do
not touch the drill
bit
or the workpiece immediately after operation; they
may be extremely hot and could burn your skin.
SYMBOLS
The followings show the symbols used for tool.
v
.................................
volts
-
-_--
.................................
direct current
n,
.................................
no load speed
..Jmin
................................
revolutions or reciprocation per minute
5