ENGLISH (Original instructions) INSTRUCTION MANUAL Angle Drill 6300LR 002994 DOUBLE INSULATION IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model 6300LR Capacities No load speed (min-1) Steel 13 mm Wood 30 mm High 800 Low 350 Without angle attachment 550 Overall length 380 mm Net weight 2.9kg Safety class /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country.
5. Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. 6. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. 7. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts.
GEB001-6 17. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. Power tool use and care 18. Do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 19. Do not use the power tool if the switch does not turn it on and off.
When you wish to attach the drill chuck to the opposite end to change the speed, proceed as follows. First, open the chuck jaws completely and then remove the screw through the chuck opening by turning it clockwise (left hand threaded screw) with the hex wrench. Grip the hex end of the spindle with the wrench and place the chuck key in one of the key holes. Hammer the chuck key lightly in the direction of the arrow (counterclockwise) until the drill chuck can be removed.
Installing side grip (auxiliary handle) break through the workpiece. A stuck bit can be removed simply by setting the reversing switch to reverse rotation in order to back out. However, the tool may back out abruptly if you do not hold it firmly. Always secure small workpieces in a vise or similar hold-down device. Avoid drilling in material that you suspect contains hidden nails or other things that may cause the bit to bind or break. • Screw the side grip on the tool securely.
ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
Makita Corporation Anjo, Aichi, Japan 883216D226 8 www.makita.