Drywall Screwdriver Instruction Manual

8
Refer to the figure for the relationship between the number
settings on the adjusting dial and the kind of work.
A range:
For work that requires a subtle speed control such as center-
ing or final fastening.
B range:
Use when screws/drywall boards might be damaged with C
range speed.
C range:
For regular fastening work.
NOTE:
• The above figure shows standard applications. They
may differ under certain conditions.
CAUTION:
• If the tool is operated continuously at low speeds for a
long time, the motor will get overloaded, resulting in tool
malfunction.
• The speed adjusting dial can be turned only as far as 5
and back to 1. Do not force it past 5 or 1, or the speed
adjusting function may no longer work.
Hook
The hook can be installed on either side of the tool. To change
the hook position, remove the thumb screw and hook. Replace
the hook so that its bent portion will be on the other side.
The space between the hook and the tool itself can be adjusted
to provide more 37 mm (1-7/16”) or less 17 mm (11/16”) room
for temporarily hanging the tool. To adjust, remove the thumb
screw and hook. Then use the other hole when securing with
the thumb screw.
002639
4500
1500
12345
A
B
C
(rpm)
Dial setting
No load speed
1. Hook
2. Thumb screw
1
2
17mm(11/16 )
or 37mm(1-7/16 )
002643