ENGLISH (Original instructions) INSTRUCTION MANUAL Auto Feed Screwdriver 6842 6843 6844 6846 008120 DOUBLE INSULATION IMPORTANT: Read Before Using.
ENGLISH (Original instructions) SPECIFICATIONS Model 6842 Screw strip No load speed (min-1) 6843 6846 4 mm x 25 mm - 55 mm 4,700 6,000 Overall length 400 mm Net weight 2.0 kg Safety class 6844 4 mm x 45 mm - 75 mm 3,000 440 mm 2.1 kg /II • Due to our continuing programme of research and development, the specifications herein are subject to change without notice. • Specifications may differ from country to country.
ENH101-14 you to lose control. Electrical safety 4. Power tool plugs must match the outlet. Never modify the plug in any way. Do not use any adapter plugs with earthed (grounded) power tools. Unmodified plugs and matching outlets will reduce risk of electric shock. 5. Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. 6. Do not expose power tools to rain or wet conditions.
GEB017-4 of the power tool in unexpected situations. Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing, and gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts. 17. If devices are provided for the connection of dust extraction and collection facilities, ensure these are connected and properly used. Use of dust collection can reduce dust-related hazards. Power tool use and care 18. Do not force the power tool.
Changing the installation position of hook allows two-way setting of 10 mm and 20 mm distance from the tool itself. The tool with hook can be hung on the waist belt, a maximum diameter 20 mm pipe etc. To remove the hook, just remove the clamping screw. Place it on the tool and secure it with the clamping screw to install. FUNCTIONAL DESCRIPTION • CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action 1. Hook 2.
Depress the stopper base as far as it will go. While keeping it in this position, turn the adjusting knob until the bit tip projects approx. 5 mm from the stopper base. Drive a trial screw. If the screw head projects above the surface of the workpiece, turn the adjusting knob in the "A" direction; if the screw head is counter-sunk, turn the adjusting knob in the "B" direction. Setting for desired screw length 1. Lever 2. Stopper base 3. Label on feeder box 4.
workpiece. 1. Reverse button • 1 • 008128 Folding screw guide • • CAUTION: Always hold the tool squarely against the driving surface. Holding it at an angle may damage the screw heads and cause wear on the bit. This may also lead to poor fastening. Always keep the tool firmly against the driving surface until the driving is over. Failure to do so may cause insufficient fastening of screws. Be careful not to drive a screw onto another screw already fastened. Do not operate the tool without screws.
Replacing carbon brushes 1. Limit mark 1 001145 Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes. Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. 1 2 1. Brush holder cap 2.
Makita Corporation Anjo, Aichi, Japan 884722B224 12 www.makita.
