Instruction manual

4
ENGLISH (Original Instructions)
Explanation of general view
SPECIFICATIONS
•Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
•Specifications may differ from country to country.
•Weight according to EPTA-Procedure 01/2003
Symbols
END202-6
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
...... Read instruction manual.
................ DOUBLE INSULATION
...... Wear safety glasses.
Intended use
ENE048-1
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Power supply
ENF002-2
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
ENF100-1
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects to
the operation of other equipment. With a mains
impedance equal or less than 0.31 Ohms it can be
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
General Power Tool Safety
Warnings
GEA005-3
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
The term “power tool” in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool. Distractions can cause you
to lose control.
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
1. Shaft lock
2. Switch trigger
3. Lock lever
4. Wheel guard
5. Bearing box
6. Screw
7. Lock nut
8. Depressed center wheel
9. Super flange
10. Inner flange
11. Lock nut wrench
12. Outer flange 78
13. Cut-off wheel
14. Inner flange 78
15. Dust collecting wheel guard
16. Exhaust vent
17. Inhalation vent
18. Commutator
19. Insulating tip
20. Carbon brush
21. Brush holder cap
22. Screwdriver
Model 9067/9067S 9067L 9069/9069S
Depressed center wheel diameter 180 mm 180 mm 230 mm
Spindle thread M14 M14 M14
No load speed (n
0
) / Rated speed (n) 8,500 min
-1
6,600 min
-1
6,600 min
-1
Overall length 458 mm 458 mm 458 mm
Net weight 5.2 kg 5.2 kg 5.3 kg
Safety class /II