Instruction manual

6
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing side grip (auxiliary handle)
1
003445
CAUTION:
• Always be sure that the side grip is installed
securely before operation.
Screw the side grip on the tool securely. The side grip
can be installed on either side of the tool, whichever is
convenient.
Installing or removing abrasive disc
1
3
2
003455
Mount the rubber pad onto the spindle. Fit the abrasive
disc on the rubber pad and screw the lock nut onto the
spindle.
To tighten the lock nut, hold the spindle with the wrench
so that it cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
1
2
003456
To remove the disc, follow the installation procedure in
reverse.
Installing or removing the wool bonnet
1
2
3
003461
Mount the rubber pad onto the spindle. Screw the lock
nut onto the spindle.
To tighten the lock nut, hold the spindle with the wrench
so that it cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
Fit the wool bonnet completely over the rubber pad and
pull the string tight. Tie a bow knot and tuck the knot and
any loose strings between the wool bonnet and the
rubber pad.
003462
To remove the wool bonnet, follow the installation
procedure in reverse.
OPERATION
Sanding operation
15
003471
CAUTION:
• Always wear safety goggles or a face shield during
operation.
• Never switch on the tool when it is in contact with
the workpiece, it may cause an injury to operator.
1. Wool bonnet
2. Lock nut
3. Rubber pad
1. Lock nut wrench
2. Wrench
1. Lock nut
2. Abrasive disc
3. Rubber pad
1. Side grip