Instruction manual

HOW TO USE
Switch action
To start the tool, simply pull the trigger.
Release the trigger to stop. For continuous
operation without having to keep your
finger on the tirgger, just pull the trigger
and then push in the lock button with
your thumb. To stop the tool from the
lock position, simply pull the trigger again
and release
it.
Speed changes
If the knob on the switch lever in front is
turned to the "H" setting, the high speed is
obtained; if set to the "L" setting, the low
speed results. Use the suitable speed setting
in order to obtain the
best performance
finish.
iigh speed
. . . . . For disc sanding
.ow speed
. . . . . . For polishing
ani
I I
Fig. 1
Trigger switch
Speed change
knc
Arrow indication
F ig.2
Knob setting in terms of speed
The tool speed can be set for anywhere from 1,500 to 2,800 rpm. Simply align any knob
numbered setting with the arrow indicator. Consult chart below for approximate
speeds
obtained for each of the numbered settings.
You can also obtain speeds other than the settings by adjusting the knob in between.
For example, for 2,150 rpm, align
so that arrow will be pointed halfway between the
numbers
3 and 4.
CAUTION : Numbered Setting
The knob for speed settings can be turned
only
as far as 6 and back to 1. Do not force
the knob
past 6 or the speed change func-
tion may no longer work.
2000
2300
5 2550
6 2800
CAUTION
ALWAYS SWITCH OFF AND UNPLUG THE TOOL
BEFORE INSTALLING OR RE-
MOVING A SANDING DISC OR WOOL BONNET.
5