User Manual

MAINTENANCE
CAUTION :
Always be sure that the tool is switched off and unplugged before attempting to perform
Use
a screwdriver to remove the brush
holder caps. Take out the worn carbon
inspection or maintenance.
Replacing carbon brushes
1 Brush holder cap
Remove and check the carbon brushes
I
regularly. Replace when they wear down
to the limit mark. Keep the carbon brushes
clean and free to
sliD in the holders. Both
. ~-.
carbon brushes should be replaced at the I 7
same time. Use only identical carbon
brushes.
L Limit mark
brushes, insert the new ones and secure the
brush holder caps.
I -Screwdriver
I
Fig. 11
CAUTION :
Never remove the breather from the gear
housing.
It is not an oil cap.
///
Fig. 1
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
12