User Manual
11.
Causes and Operator Prevention
of
Kickback:
Kickback is a sudden reaction to a pinched, bound or misaligned saw blade,
causing an uncontrolled saw to lift up and
out
of the workpiece toward the
operator.
When the blade is pinched or bound tightly by the kerf closing down, the blade
stalls and the motor reaction drives the unit rapidly back toward the operator.
If the blade becomes twisted or misaligned in the cut, the teeth at the back
edge of the blade can dig into the top surface of the wood causing the blade
to climb out of the kerf and jump back toward operator.
Kickback is the result of tool misuse and/or incorrect operating procedures
or conditions and can be avoided by taking proper precautions as given below.
Maintain a firm grip with both hands on the saw and position your body and
arm to allow you to resist
KICKBACK
forces. KICKBACK forces can be
controlled by the operator, if proper precautions are taken.
When blade is binding, or when interrupting a cut for any reason, release
the trigger and hold the saw motionless in the material until the blade comes
to a complete stop. Never attempt to remove the saw from the work
or
pull
the saw backward while the blade
is
in motion
or
KICKBACK
may occur.
Investigate and take corrective actions to eliminate the cause of blade binding.
When restarting a saw in the workpiece, center the saw blade
in
the kerf
and check that saw teeth are not engaged into the material. If saw blade
is binding, it may walk up or KICKBACK from the workpiece as the saw is
restarted.
Support large panels to minimize the risk of blade pinching and
KICKBACK.
Large panels tend to sag under their own weight. Supports must
be
placed
under the panel on both sides, near the line of cut and near the edge of the
panel as shown in Fig.
1.
To
minimize the risk of blade pinching and kickback. When cutting operation
requires the resting of the saw on the work piece, the saw shall be rested
on the larger portion and the smaller piece cut off.
To
avoid kickback, do support board
or panel near the cut.
Fig.
1
Don’t support board or panel away
or panel near the cut.
Fig.
:
5