Instruction manual

6
1
2
3
4
007280
Installing coolant reservoir (Tank)
Insert the reservoir legs into the grooves provided for
them on the sharpener frame.
1
2
007281
Adjusting coolant flow
Put water in the coolant reservoir. Turn the knob so that
the marking is positioned vertically to make the coolant
flow.
1
2
3
4
007282
Turn the marking to the horizontal position to stop the
coolant flow.
1
2
3
4
007283
NOTE:
• Adjust the coolant flow adequately. If the debris
from the grinding wheel and the blade is washed
away by the coolant, the coolant flow is excessive.
Draining used coolant
The used coolant drains out through the drain hose
(vinyl tube) provided. Have a pan or drain system ready
to catch it.
1
007284
OPERATION
Sharpening blade/knife
After you have established the correct coolant flow, you
can begin sharpening. Sharpen with the cutting edge
away from you, holding the sharpening holder with both
hands. Slide the sharpening holder back and forth on
the sharpening platform guide at a speed of about ten
times per minute, applying uniform pressure (about 5
kg ) on it.
007286
CAUTION:
• Always use sharpening platform guide or guide
assembly (optional accessory) when sharpening
blade/knife.
Remove some stock from the tip to the heel in relation
to the original grinding angle so as to create a better
cutting edge.
1
2
3
007287
1. Original (proper)
grinding angle
2. Take down this
area slightly in
relation to
original angle
3. Tip (correct
sharpening
angle)
1. Drain hose
(Vinyl tube)
1. Coolant
reservoir (Tank)
2. Knob
3. Water
4. Marking
1. Coolant
reservoir (Tank)
2. Knob
3. Water
4. Marking
1. Coolant
reservoir (Tank)
2. Grooves
1. Wheel
2. Left-hand
fastening screw
3. Left-hand
(forward) adjust
screw
4. Planer blade